Taewoo MachineryCo.,Ltd.

Operating

Before operating, check the following :

• Confirmation in advance :
  • Open Motor Fan Cover and use your hand to check that the fan is turning.
  • If you cannot turn the motor fan because its Impeller is covered by hardened slurry buildup, drain slurry to the bottom of Impeller before operating.
  • As slurry may harden and built up after stopping, always use the hand-turning technique to check that the fan is free of slurry and turning.
  • If you operate the machine with hardened slurry buildup, Reducer, Shaft, and/or Impeller may be seriously damaged.
• Are the setting bolts of each part properly fastened (refer to Bolt Fastening Torque Chart)?
• Is the Tank properly fixed?
  • If tank is shaking (vibrating), the resonance might cause the shaft to bend.
• Is oil level appropriate?
• Did you check the direction of turning?
  • The Impeller’s direction of turning is shown with an arrow (clockwise).
  • When you are facing Impeller from the top of Motor, it should turn clockwise.
• Plug the power and operate the machine when all of the above are checked and it is ready to operate.

Safety Suggestions

• Install the Ammeter near the switch.
• Establish plans so that the machine is automatically stopped whenever rated current is exceeded during operation.
• If you hear an abnormal sound, stop the operation and check the machine.

Repair

If there was an incident that requires professional service, please contact our A/S Center. Please provide the following when you contact us.

• Information on the Name Plate (Type, Number, Manufacture Date, Manufacture Number)
• Place of Purchase
• Parts
• Mixer Information
• Lubricating Plan (last lubrication, etc

Safety Suggestions

• Do not operating the empty tank after connecting mixing shaft Absolutely.
• The lowest surface of liquid should be maintenance more than 1.5 times of impeller diameter above impeller.
• If you operate the empty tank. the shaft may bend or the bearing, motor, and gear may be damaged.